Workshop Repair and Service Manuals GMC SIERRA
Articles

Electrical

PIT4821C (Hybrid) High Voltage 2-Mode Battery Parts Restriction-TAC - (Mar 15 2013) Low Voltage Battery - part 2      Upon review of the diagnosis, TAC will establish a case referencenumber, and if necessary, make arrangements for ordering a hybrid battery assembly. Important:The Hybrid battery assembly can now be internally serviced, however...
PIT4821C (Hybrid) High Voltage 2-Mode Battery Parts Restriction-TAC - (Mar 15 2013) Low Voltage Battery      Subject: (Hybrid) High Voltage 2-Mode Battery Parts Restriction-TAC Models:  2009-2013 Cadillac Escalade 2008 - 2013 Chevrolet Tahoe and GMC Yukon Hybrid 2009-2013 Chevrolet Silverado and GMC Sierra Hybrid...
Rearview Driver Information Camera Package Installation (Rearview Mirror) - part 4      Re-engage Roof Console Assembly-(3) to the headliner.Re-install the two Roof Console Screws-(2) into the Assembly-(3). Tighten Tighten the two screws to 2-Y (18-lb-in).Re-install the Front Overhead Console Lens-(1)....
Rearview Driver Information Camera Package Installation (Rearview Mirror) - part 3      Adjust the mirror-(2) to the full upward position.Remove the base trim cover, if present.Loosen the Screw-(3).Slide the mirror assembly-(2) in an upward motion in order to remove from mountingtab-(1), and discard. Remove...
Rearview Driver Information Camera Package Installation (Rearview Mirror) - part 2      If the vehicle is not equipped with factory Endgate Lock, install new Handle as follows.If equipped, skip this step.Install the new Endgate Latch Handle-(2) into the Endgate.Install the two upper Endgate Latch Handle...
Rearview Driver Information Camera Package Installation (Rearview Mirror)      Installation Instructions Part Number 19201804 Rearview Camera Kit Contents Description Instruction Sheet Template (P/N 19172564) Camera/Module/Bezel Assembly Inside Rearview Mirror with Monitor (ISRVM)...
Rearview Driver Information Camera Package Installation (Nav Radio) - part 5      the delay that is received after shining out of re- verse (r) is approximately 10 seconds. the delay can be cancelled by performing one of the following: pressing hard key on the navigation system or touching the navigation...
Rearview Driver Information Camera Package Installation (Nav Radio) - part 4      Re-install the Knee Bolster Assembly-(2) with the screws-(1). Tighten Tighten the screws to 2-Y (18-lb-in). Re-install Parking brake Release Handle and Bolt. Tighten Tighten the bolt to 9-Y (80-lb-in).Chassis Harness Install...
Rearview Driver Information Camera Package Installation (Nav Radio) - part 3      Route the navigation radio harness along the left side I/P floor air duct-(1) to thenavigation radio. c46 (7641) 10 11 12 13 14 15 16 For model year 2007-2011 disconnect the C4 connector (BN) from the navigation radioand...
Rearview Driver Information Camera Package Installation (Nav Radio) - part 2      If the vehicle is not equipped with factory Endgate Lock, install new Handle as follows.If equipped, skip this step.Install the new Endgate Latch Handle-(2) into the Endgate.Install the two upper Endgate Latch Handle...
Rearview Driver Information Camera Package Installation (Nav Radio)      Installation Instructions Part Number 20906137 Rearview Camera Kit Contents Description Instruction Sheet Template (P/N 19172564) Camera/Module/Bezel Assembly Chassis Harness (Long) NAV Radio Harness...
Relay Replacement (Attached to Wire Harness) Relays      Removal Procedure Locate the relay. Refer to theMaster Electrical Component Listto locate the relay in the vehicle.Remove any fasteners which hold the relay in place.Remove any connector position assurance (CPA) devices or...
Relay Replacement (Within an Electrical Center) Relays      Special Tools EL-43244 Relay Puller Pliers Removal ProcedureRemove the electrical center cover. Note: Always note the orientation of the relay.If equipped with a notch style relay; observe the location of the notch on the...
Relay Rod Replacement (Dual Rear Wheels or Crew Cab With SRW) Relays      Special Tools J 24319-BSteering Linkage and Tie Rod Puller For equivalent regional tools, refer toSpecial Tools. Removal ProcedureRemove the engine shield, if equipped. Refer toEngine Shield Replacement.Remove the steering...
Relay Rod Replacement (SRW Except Crew Cab With SRW) Relays      Relay Rod Replacement Callout Component Name Preliminary ProceduresRaise and support the vehicle. Refer toLifting and Jacking the Vehicle.Remove the engine shield, if equipped. Refer toEngine Shield Replacement.Remove...
Special Tools      Illustration Tool Number/Description EL 38758 EL 50074 J 38758 Parasitic Draw Test Switch EL 50313 EL 42000 EL 50076 J 42000 Battery Tester EL-48900 HEV Safety Kit...
Special Tools      Illustration Tool Number/Description EL-38758 EL-50074 J-38758 Parasitic Draw Test Switch EL-50313 EL-42000 EL-50076 J-42000 Battery Tester
Starter Replacement (Diesel)      Starter Replacement Callout Component Name Preliminary ProceduresDisconnect the battery negative cable. Refer toBattery Negative Cable Disconnection and Connection.Remove the right side front wheelhouse liner.Refer...
Theft Deterrent Alarm Package Installation - part 3      Secure with a tie strap. maximum to minimum sensitivity The Shock Sensor shold be mounted with the WHITE adjustment knob positioned towardthe floor for easy access and tuning the sensitivity level.Arm the vehicle’s content...
Theft Deterrent Alarm Package Installation - part 2      Attemptto reprogram the control module. If the control module cannot be programmed, replacethe control module.Reprogram the IPC (Instrument Panel Cluster) using the method called out by TCSC.Reprogram the BCM (Body Control...
Theft Deterrent Alarm Package Installation      Installation Instructions Part Number 19169630 The vehicle must have the keyless entry option (&AU0), (AP3), (AP8) and DIC (&UK3)or the GM accessory DIC switch package for this security system. Otherwise, it doesnot have the...
Theft Deterrent Vehicle Inclination Sensor Package Installation (Installation Instruction 22962507) - part 2      If an interruption occurs, programmingfailure or control module damage may occur.DO NOT turn OFF the ignition if the programming procedure is interrupted or unsuccessful.Ensure that all connections are secure and the SPS...
Theft Deterrent Vehicle Inclination Sensor Package Installation (Installation Instruction 22962507)      Installation Instructions Part Number 22962507 The vehicle must have the keyless entry option (&AP3/AP8/AU0) and DIC (&UK3) or theGM accessory DIC switch package for this security system. Otherwise, it doesn’t havethe...
Underhood Electrical Center or Junction Block Bracket Replacement Junction Box      Underhood Electrical Center or Junction Block Bracket Replacement Callout Component Name Preliminary Procedure Remove the underhood electrical center/junction block. Refer toUnderhood Electrical Center or Junction...