Workshop Repair and Service Manuals GMC SIERRA
Articles

Electrical

03-06-03-003C ACDelco Replacement Battery Warranty Procedures - (Apr 15 2013) Low Voltage Battery - part 2      Do not include labour hours to replace the battery.If no parts were replaced and only repairs were necessary, enter labour time in the“Labour Hours” field and other material in the “Net Misc” field.The battery part number and...
03-06-03-003C ACDelco Replacement Battery Warranty Procedures - (Apr 15 2013) Low Voltage Battery      Subject: ACDelco® Replacement Battery Warranty Procedures Models:  2014 and Prior GM Passenger Cars and Trucks Attention:  “GM of Canada” and “IPC” Service Agents are not authorized to utilize this...
03-06-03-004J Warranty Code Generated By EL-50313 Midtronics GR8 Battery Tester Charger Required for Claim Processing On Labor Operation 4041510 and 250 Mile 400 Km Labor Operation Restriction (North America ONLY) - (Oct 25 2013) Low Voltage Battery - part 3      Important:The complete code 15 Characters (17 characters with optional hyphen) must be enteredinto the Labor Code Dependency Field in GWM. Note:To warranty administrators, the following characters are not used in the...
03-06-03-004J Warranty Code Generated By EL-50313 Midtronics GR8 Battery Tester Charger Required for Claim Processing On Labor Operation 4041510 and 250 Mile 400 Km Labor Operation Restriction (North America ONLY) - (Oct 25 2013) Low Voltage Battery - part 2      Important:To access downloads on this website you must first register and establish a user nameand password.  A link is provided at bottom of page to “Create an account” or ContactDES at 1-866-868-3372 if assistance is needed....
03-06-03-004J Warranty Code Generated By EL-50313 Midtronics GR8 Battery Tester Charger Required for Claim Processing On Labor Operation 4041510 and 250 Mile 400 Km Labor Operation Restriction (North America ONLY) - (Oct 25 2013) Low Voltage Battery      Subject: Warranty Code Generated By EL-50313 Midtronics GR8 Battery Tester/Charger Requiredfor Claim Processing On Labor Operation 4041510 and 250 Mile/400 Km Labor OperationRestriction (North America ONLY) Models:...
07-08-47-004E Information on Body Control Module (BCM) Grounds - (May 20 2013)      Subject: Information on Body Control Module (BCM) Grounds Models:  2006-2011 Buick Lucerne 2008-2014 Buick Enclave 2006-2011 Cadillac DTS 2007-2009 Cadillac SRX 2007-2014 Cadillac Escalade Models...
08-06-03-006B Engine Running with Key Off Continuous Run - Sensing and Diagnostic Module (SDM) No Communication Service Air Bag Light Illuminated DTCs B1440 P0381 or P0650 (Install Diode to Solenoid Relay) - (Aug 2 2012) Relays - part 2      Be sure to insulate the diode withheat shrink tubing before installing. Parts Information Part Number Description Qty 12112422 Diode 1 Warranty Information This repair will not be covered under warranty due to...
08-06-03-006B Engine Running with Key Off Continuous Run - Sensing and Diagnostic Module (SDM) No Communication Service Air Bag Light Illuminated DTCs B1440 P0381 or P0650 (Install Diode to Solenoid Relay) - (Aug 2 2012) Relays      Subject: Engine Running with Key Off, Continuous Run – Sensing Diagnostic Module (SDM), NoCommunication, Service Air Bag Light Illuminated, DTCs B1440, P0381 or P0650 (InstallDiode to Solenoid/Relay) Models:...
09-08-45-003E Installation of Electrical Aftermarket Accessories on 2-Mode Hybrid Full Size Trucks - (Jun 21 2012) - part 6      This fuse must be equal in size to the powerside fuse. Connect the circuit(s) to the accessory.Reinstall the fuse block base and cover.Tie rap the fuse block/harness back into the original location.Reconnect the battery feed...
09-08-45-003E Installation of Electrical Aftermarket Accessories on 2-Mode Hybrid Full Size Trucks - (Jun 21 2012) - part 5      The ignition is controlled through either a single relay(RPO WRJ) or dual relays (RPO WRK). Chassis ground can also be accessed at both the front compartment and rear cargo areafuse blocks. Accessing Power and Ground from the...
09-08-45-003E Installation of Electrical Aftermarket Accessories on 2-Mode Hybrid Full Size Trucks - (Jun 21 2012) - part 4      The pin out of the connector is as follows: Cavity Circuit Description Circuit Number Fuse Size 1 Ground 1050 NA 2 Battery Feed (Do Not Use) 4540 15 Amps 3 Not Used — — 4...
09-08-45-003E Installation of Electrical Aftermarket Accessories on 2-Mode Hybrid Full Size Trucks - (Jun 21 2012) - part 3      Relay Installation radio relay pin pin (30) (86) relay (37a) (37) (as) 10 radio (1 d50) Install relay (P/N-12193601) with 5-way pigtail connector (P/N-15306045) as shownin the above diagram to ensure the load from the radio...
09-08-45-003E Installation of Electrical Aftermarket Accessories on 2-Mode Hybrid Full Size Trucks - (Jun 21 2012) - part 2      winches, power inverters, etc.) on 2011 and beyond GM Hybrid trucks,please refer to the GM Upfitter Integration website at www.gmupfitter.com. The guidelinesbelow apply to the use of existing OEM power distribution centers and...
09-08-45-003E Installation of Electrical Aftermarket Accessories on 2-Mode Hybrid Full Size Trucks - (Jun 21 2012)      Subject: Installation of Electrical Aftermarket Accessories on 2-Mode Hybrid Full Size Trucks Models:  2008-2013 Cadillac Escalade Hybrid 2008-2013 Chevrolet Tahoe Hybrid 2009-2013 Chevrolet Silverado Hybrid...
10-08-45-001D Information for Electrical Ground Repair - Use New Replacement Fasteners with Conductive Finish - (Feb 14 2013) - part 4      Drill a 10 mm (0.40 in) diameter hole through the panel. Remove paint and primer from the area surrounding the 10 mm (0.40 in) until bare metalis visible. Important:The M6 conductive rivet stud as shown, can accommodate a...
10-08-45-001D Information for Electrical Ground Repair - Use New Replacement Fasteners with Conductive Finish - (Feb 14 2013) - part 3      The oxidized wear debriscan accumulate at the electrical contact points causing the electrical resistanceacross the connection to increase. Carefully remove ANY corrosion or contamination that may be present on the electrical...
10-08-45-001D Information for Electrical Ground Repair - Use New Replacement Fasteners with Conductive Finish - (Feb 14 2013) - part 2      The oxidized wear debriscan accumulate at the electrical contact points causing the electrical resistanceacross the connection to increase. Carefully remove ANY corrosion or contamination that may be present on the electrical...
10-08-45-001D Information for Electrical Ground Repair - Use New Replacement Fasteners with Conductive Finish - (Feb 14 2013)      Subject: Information for Electrical Ground Repair — Use New Replacement Fasteners with ConductiveFinish Models:  2014 and Prior GM Passenger Cars and Trucks     This bulletin is being revised to add the...
12-08-132-001A Accessory Power Outlet and Trailer Lighting Fuse Replacement Labor Operation N1720 Fuse Replacement - (Mar 26 2013) Fuses      Subject: Accessory Power Outlet and Trailer Lighting Fuse Replacement Labor Operation N1720Fuse Replacement Models:  2010-2014 GM Passenger Cars and Trucks     This bulletin is being revised to add the 2014...
13-08-116-001A Aftermarket ALDL or DLC Interface Devices Causing Multiple Issues - (Mar 22 2013) - part 2      Theexamples below illustrate some of the devices encountered. Examples: The monitoring device examples are not specific to any one design, and styles willvary. Device W/Secondary DLC Connector This device has another DLC...
13-08-116-001A Aftermarket ALDL or DLC Interface Devices Causing Multiple Issues - (Mar 22 2013)      Subject: Aftermarket ALDL or DLC Interface Devices Causing Multiple Issues Models:  2006-2014 GM Passenger Cars and Trucks     This bulletin is being revised to add additional possible symptoms, clarify the...
175 Amp Mega Fuse Replacement (Auxiliary Battery) Low Voltage Battery      175 Amp Mega Fuse Replacement Callout Component Name Preliminary Procedures Disconnect the battery negative cable. Refer toBattery Negative Cable Disconnection and Connection. 1 Mega-Fuse Holder Nut...
200 Amp Mega Fuse and Auxiliary Electrical Center 12VDC Junction Block Replacement Junction Box      200 Amp Mega Fuse and Auxiliary Electrical Center 12VDC Junction Block Replacement Callout Component Name Preliminary ProceduresDisconnect the battery negative cable. Refer toBattery Negative Cable Disconnection and...
Auxiliary Body Control Module Replacement Body Control Modules      Auxiliary Body Control Module Replacement Callout Component Name Preliminary Procedures Remove the inflatable restraint module. Refer toAirbag Instrument Panel Module Replacement. 1 Auxiliary Body Control...