Workshop Repair and Service Manuals GMC SIERRA
Articles

1-2-3-4-5-6 Clutch Piston Housing Assembly Installation Automatic

Rating:

Special ToolsJ-36850 Transjel® LubricantJ-44587 Main Shaft Holder

For equivalent regional tools, refer toSpecial Tools.

1-2-3-4-5-6 Clutch Piston Housing Assembly Installation Automatic

Position the transmission case so that the front of the case is facing up.Remove 2 bolts-(2) from J-44587 holder-(1).Remove J-44587 holder from the power take-off-(PTO) access.

1-2-3-4-5-6 Clutch Piston Housing Assembly Installation Automatic

Apply J-36850 lubricant or equivalent lubricant to the thrust bearing assembly-(1).

Caution:Installing the thrust bearing incorrectly may cause permanentdamage to the transmission.

Align the thrust bearing-(1) so that the blue stripe on the thrust bearing is facingtowards the input carrier assembly.Install the thrust bearing-(1) into the input carrier assembly.

1-2-3-4-5-6 Clutch Piston Housing Assembly Installation Automatic

Install the 1–2–3–4, 4–5–6 clutch assembly-(1).Rotate the clutch assembly until the assembly seats.Make sure one of the following is visible through the speed sensor hole in the transmissioncase:The teeth of the PTO gearThe teeth of the turbine tone wheel

PIP4833D Auxiliary Transmission Fluid Pump (ATFP) Control Module And Pump Parts Restriction - (Aug 8 2012) Automatic     Subject: Auxiliary Transmission Fluid Pump (ATFP) Control Module And Pump Parts Restriction Models:  2009-2013 Cadillac Escalade 2008-2013 Chevrolet Tahoe 2009-2013 Chevrolet Silverado 2009-2013 GMC...
Reverse Automatic     When the gear selector lever is moved to the Reverse (R)position (from the Park position) the normally high C35R pressurecontrol solenoid 2 is commanded ON and the following changes occurin the transmission’s hydraulic and...
Electronic Component Description Automatic     Electronic Components (6) A/Trans Auxiliary Fluid PumpAssembly (31) A/Trans Manual Shift Shaft PositionSwitch Assembly (71) Drive Motor (w/Generator)Assembly-–-1st Position (88) Drive Motor...
Transmission Fluid Drain and Fill Automatic     Special Tools J 36511 Oil Fill/Drain Plug Hex Bit (17-mm) Removal Procedure Raise and suitably support the vehicle. Refer toLifting and Jacking the Vehicle.Using J 36511 oil fill/drain plug hex bit (17-mm) remove the oil...
1-2-3-4-5-6 Clutch Piston Housing Disassemble Automatic     Special ToolsJ 24204-2Bar and Stud AssemblyJ 43772Torque Converter Seal InstallerJ 47339-1Piston Return Spring CompressorJ 47339-2Seal Area Protector For equivalent regional tools, refer toSpecial Tools. Position the...
3rd 5th and Reverse Clutch Removal Automatic Transmission Unit Automatic Clutches     Special ToolsJ 24204-2Bar and Stud AssemblyJ 44530Clutch Piston Spring Compressor For equivalent regional tools, refer toSpecial Tools. Position the transmission case so that the front of thetransmission case is facing up....