Workshop Repair and Service Manuals GMC SIERRA
Articles

1-2-3-4 and 3-5 Reverse Clutch Assembly and 4-5-6 Clutch Assembly Removal (6L50 80 90) Manual Clutch

Rating:

1-2-3-4 and 3-5 Reverse Clutch Assembly and 4-5-6 Clutch Assembly Removal (6L50/80/90) Manual Clutch

1-2-3-4 and 3-5 Reverse Clutch Assembly and 4-5-6 Clutch Assembly Removal

Callout

Component Name

1

1–2–3–4 and 3–5Reverse Clutch Assembly and4–5–6-(With Turbine Shaft) ClutchAssembly

2

Turbine Shaft Thrust Bearing Assembly

3

4–5–6 Clutch-(With OutputCarrier Shaft and Dampener) Hub Assembly

4

4–5–6 Clutch Hub Thrust BearingAssembly

5

1–2–3–4 Clutch-(WithOutput Carrier Inner Sun Gear Shaft) Hub Assembly

6

1–2–3–4 Clutch Hub ThrustBearing Assembly

7

2–6 and 3–5 ReverseClutch-(With Output Carrier Outer Sun Gear Shaft) HubAssembly

8

2–6 and 3–5 Reverse Clutch Hub ThrustBearing Assembly

9

1–2–3–4 and 3–5Reverse Clutch Assembly

10

Input Carrier Assembly

11

Input Sun Gear

12

Input Sun Gear Thrust Bearing

13

Input Sun Gear Thrust Washer

14

4–5–6-(With Turbine Shaft)Clutch Assembly

Electronic Component Description Automatic     Electronic Components (6) A/Trans Auxiliary Fluid PumpAssembly (31) A/Trans Manual Shift Shaft PositionSwitch Assembly (71) Drive Motor (w/Generator)Assembly-–-1st Position (88) Drive Motor...
Transmission Identification Information Automatic Transmission Unit     Figure 1: Nameplate Location Figure Transmission Identification Information Figure 2: Nameplate Figure Transmission Identification Information
PIP4793G PQC Restriction Allison A1000 Transmission Valve Body RPO MW7 - (Jun 27 2013) Automatic Transmission Unit Control Valve Body     Subject: PQC Restriction Allison A1000 Transmission Valve Body RPO MW7 Models:  2012-2014 Chevrolet Silverado 2012-2014 GMC Sierra, Sierra Denali Equipped with Allison A1000 Transmission RPO MW7 This PI...
Second Range (Without TCC Applied) Automatic     Before shifting from first to second range, the transmissioncontrol module-(TCM) makes certain shiftvalve-1, shift valve-2, and shiftvalve-3 are in the correct position with shiftvalve-1 and shift valve-2 de-stroked andshift...
Locking Differential Clutch Disc Assembly Assemble (9 5LD Axle) Manual Clutch Friction Material     Apply proper axle lubricant to the surface of each disc.Refer toAdhesives, Fluids, Lubricants, and Sealers.Assemble the right side or bell-end side clutch disc assemblyas follows:Install the 1st non-carbon eared disc-(3) to...
Clutch Assembly Replacement Manual Clutch     Special Tools J-5824-A Clutch Alignment Tool Removal ProcedureRemove the transmission. Refer toTransmission Replacement. Remove the clutch pressure plate bolts. Note:Dowel pins are used to align the flywheel and pressure...