Workshop Repair and Service Manuals GMC SIERRA
Articles

Brake Fluid Level Indicator Switch Replacement (Non-Hybrid)

Rating:

Brake Fluid Level Indicator Switch Replacement (Non-Hybrid)

Brake Fluid Level Indicator Switch Replacement

Callout

Component Name

Preliminary Procedure

Disconnect the master cylinder fluid level sensor electricalconnector.

1

Master Cylinder Fluid Level Sensor

Tip:Compress the locking tabs on the sensor to release the sensorfrom the brake master cylinder reservoir.

PIT4595H Service Trailer Brake Message With DTC C1114 And Or C1112 - (Aug 27 2012) - part 2     Clean as required.With the ignition on, use Tech 2 to monitor TBCM Relay Feedback Signal. Monitor signalfor 10-15 seconds. Determine the minimum voltage value that occurs. (This voltagevaries once per second and always settles...
Brake Pad and Rotor Burnishing Disc Brakes Brake Pads     Warning:Road test a vehicle under safe conditions and while obeyingall traffic laws. Do not attempt any maneuvers that couldjeopardize vehicle control. Failure to adhere to these precautionscould lead to serious personal...
00-05-22-002N Disc Brake Warranty Service and Procedures - (May 31 2013) Disc Brakes - part 3     Important:Prior to making the cut, install the recommended clip-on style disc silencer suppliedwith the lathe. Use of this silencer is critical to prevent chatter from occurringduring the cut. Bench Type LatheRefinish the...
00-05-22-002N Disc Brake Warranty Service and Procedures - (May 31 2013) Disc Brakes - part 4     Connect the lathe to the adapter, turn on the lathe and activate the computer to compensatefor run-out in the hub.Once the computer indicates the compensation process was successful, on the outboardarea of the rotor, position...
Rear Brake Hose Replacement (To Caliper - J95) Disc Brakes Brake Calipers     Removal Procedure Warning:Refer toBrake Dust Warning. Warning:Refer toBrake Fluid Irritant Warning. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle.Remove the tire and wheel assembly. Refer toTire and...
Parking Brake Lever Pedal Assembly Replacement (Without TZ0) Parking Brake Lever or Pedal     Removal ProcedureRelease the parking brake.Raise and support the vehicle. Refer toLifting and Jacking the Vehicle.Loosen the intermediate parking brake cable equalizer nut. Drill a-3-mm-(1/8-in) hole through the dimple in...