Workshop Repair and Service Manuals GMC SIERRA
Articles

Output Carrier to Output Shaft Assemble (6L80 6L90) Automatic

Rating:

Output Carrier to Output Shaft Assemble (6L80/6L90) Automatic

Output Carrier to Output Shaft Assemble

Callout

Component Name

1

Output Carrier Thrust Bearing Assembly

2

Output Carrier Internal Front Gear

Caution:Install the gear flat side down. Failure to install the gearflat side down may result in transmission damage.

3

Output Shaft Assembly

4

Output Carrier Internal Gear Retaining Ring

Note:Grasp the output shaft and carrier with both hands to turn over.

Flywheel Housing Installation Flywheel Flexplate     Install the oil cooler adapter-(3) withgaskets-(1) and (4) to the oil cooler. Caution:Refer toFastener Caution. Install the oil cooler adapter to oil coolerbolts-(2) and tighten to25-Y(18-lb-ft).Apply a 2–3-mm wide...
Reverse Idler Gear Disassemble Manual     Remove the 4th gear shaft from the case. Remove the 4-screws from the rear retainer. Remove the rear retainer and the adjuster shims. Remove the reverse shaft. Remove the reverse gear. Remove the 2-cages with...
PIP5059 Whistle Or Whine Noise In 3rd Gear May Be More Pronounced On A Coast - (Sep 6 2012)     Subject: Whistle Or Whine Noise In 3rd Gear May Be More Pronounced On A Coast Models:  2010 - 2013 Chevrolet Colorado, Express, Silverado 2010 - 2013 GMC Canyon, Savana, Sierra Equipped with 4L60E (M30)...
Auxiliary Fluid Pump Control Module Replacement Automatic Transmission Unit Transmission Oil Pump     Removal Procedure Disconnect the auxiliary fluid pump electrical wire harnessconnector-(1) from the auxiliary fluid pump controlmodule connector-(2). Disconnect the auxiliary fluid pump control module...
Hybrid Low 1-2 Clutch Piston Removal Automatic     Hybrid Low, 1-2 Clutch Piston Removal Callout Component Name 1 Hybrid Low, 1-2 Clutch Piston Retaining Ring Note:Do not reuse the retaining ring. 2 Hybrid Low, 1-2 Clutch Backing Plate Assembly 3...
2-4 Band Servo Piston Pin Length Check Automatic Transmission Unit Trans Band Servos     Special Tools J-330372-4 Intermediate Band Apply Pin Gauge Install the band apply pin-(13) and theJ-33037pin gauge.Install the servo cover retaining ring-(29) tosecure the tool. Apply 11-Y(98-lb-in) torque. If the...