Workshop Repair and Service Manuals GMC SIERRA
Articles

Piston Oil Nozzle Removal

Rating:

Piston Oil Nozzle Removal

Rotate crankshaft as necessary to obtain access to piston oilcooling nozzles.Remove the piston oil cooling nozzle eye bolt.Remove the piston oil cooling nozzle.

Separating Parts     Important:Many internal engine components will develop specific wearpatterns on their friction surfaces. When disassembling the engine, internal components MUST beseparated, marked, or organized in a way to ensure...
Exhaust Manifold Installation - Right Side Exhaust Exhaust Manifold     Caution:Refer toFastener Caution. Note: Tighten the exhaust manifold bolts as specified in the service procedure. Improperlyinstalled and/or leaking exhaust manifold gaskets may affect vehicle emissions and/oron-board...
Camshaft Removal Valvetrain Camshaft     Remove the camshaft retainer bolts-(204) andretainer-(203). Caution:All camshaft journals are the same diameter, so care must beused in removing or installing the camshaft to avoid damage to thecamshaft bearings. Remove...
Fuel Tank Fuel Pump Module Replacement Fuel System Fuel Tank     Special Tools CH–45722Fuel Tank Sender Wrench For equivalent regional tools, refer toSpecial Tools. Removal Procedure Warning:Refer toGasoline/Gasoline Vapors Warning. Remove the fuel tank. Refer toFuel Tank Replacement....
Oil Pump Installation Engine Lubrication Oil Pump     Install a new O-ring to the engine block.Lubricate the O-ring with engine oil.Install the oil pump. Caution:Refer toFastener Caution. Install the oil pump bolts and tighten to21-Y(15-lb-ft). Note:Do not damage the...
Crankshaft Balancer Replacement Engine Block Cylinder Block Crankshaft - part 2     Install the USED crankshaft balancer bolt-(139) . Tighten the USED bolt to 330-Y (240-lb-ft).Remove the USED crankshaft balancer bolt. Note:The nose of the crankshaft should be recessed 2.4–4.48-mm (0.094–0.176-in) into...